Motive Products 1820 Double Catch Bottle Kit, 500ml each, Compatible with Motive Products Power Bleeder Attachments

Meets my expectations

Great product for brake bleeder.Leave work place clean.

Makes power bleeding brake clean and simple

Better and easier to use versus a piece of tubing and an empty soda bottle. Worth the additional cost if you are buying their power bleeder bottle.

Fast shipping. The catch bottle works and performs as advertised. There is no suction so left that blank. This works in conjunction with the pressure bottle that you connect to the master cylinder. What I do is suction out the old fluid with a turkey baster or something like that. Then fill it with new fluid, in my case DOT 4, for my BMW i3, then screw down the cap of the pressure bottle on the master cylinder. Attach the Catch bottle to the brake cylinder that is located on the right rear. The one that is the greatest distance from the Master Cylinder.Pressure the system with the pressure bottle to about 10 pounds maybe 12 on the gauge, course again make sure your master cylinder is full of the required brake fluid for your vehicle. (If you want to know what the pressure bottle looks like, just check Motive products.)Go to the right rear cylinder and using a wrench that fits the bleeder valve just crack it open to where you see fluid running into your catch bottle, course you did attach the rubber hose didn't you LOLYou will probably see yellow looking fluid coming from the lines and maybe a few bubbles.Tighten up the valve, and go check the level of fluid in the Master Cylinder, DON'T ALLOW IT TO RUN DRY.If more fluid is required release the pressure on the system and refill the Master Cylinder. CAREFUL, make sure the pressure is released or fluid may spray out, if brake fluid gets on your paint, it will destroy it, and its not very helpful for your either LOL.Once you see new fluid coming from the Right Rear Tighten that bleeder valve and proceed to the left rear, then the right front, and finally the left front. Course these instructions are for Master Cylinders located on the left side, drivers side of the car, they normally are.Its a pretty simple job and saves you a couple of hundred bucks.

The hose fits right over the fitting on the caliper and doesn’t leak. Makes for a non messy brake bleed.

It's just a catch bottle. A sports bottle with a hole drilled into the lid would do the same job. No complaints.

This simple tool made collecting brake fluid easy and kept the line air free. I flushed clean fluid through the lines during a brake pad change and this bottle made it easy. Just keep the bottle above the bleeder port on your caliper. Made in USA!

Very well packaged and looks exactly like in the picture! Hoses are so flexible - they worked on most of the bleeder screws

Works great and as described, but essentially it’s a plastic container with a lid with a flexible aquarium type hose going into the container through the top of the lid which connects the the brake nipple on the other end. If you’re lazy like me excellent purchase, if you have a little drive and have those items I described laying around you can also try that.

Made bleeding the brakes on my 2018 Kia Sorento a breeze. Great capacity!

This made my bleeding efforts clean and easy.Use this in conjunction with the Motive Products power bleeder, and you’ve got a winning combination. We repaired a truck that a major brand dealership had set aside because of repeat brake failures.

Worked as needed